ISSN: 1003-6326
CN: 43-1239/TG
CODEN: TNMCEW

Vol. 20    No. 1    January 2010

[PDF]    [Flash]
Tendency of homogeneous radial deformation during
electromagnetic compression of aluminium tube
YU Hai-ping(于海平)1, LI Chun-feng(李春峰)1, LIU Da-hai(刘大海)1, MEI Xian(梅 险)2
(1. School of Materials Science and Engineering, Harbin Institute of Technology, Harbin 150001, China;
2. Computer Centre, Harbin University of Science and Technology, Harbin 150080, China
)
Abstract: Electromagnetic forming is one of the high-rate forming methods that can be extensively used to form and join axisymmetric metal sheet and tube. Tendency of homogeneous radial deformation during electromagnetic compression of aluminium tube was investigated through the design optimization method based on sequential coupling numerical simulation and experiments. The results show that the tendency depends on the length ratio of tube to coil (R), which has a critical value (Rc) corresponding to the relatively homogeneous radial deformation along axial direction. The tube length relative to Rc is insensitive to the discharge voltage. When R is greater than Rc, the deformed tube presents horn shape and the shorter coil makes for local deformation. If R is less than Rc, the deformed tube presents drum shape and the longer coil contributes to larger deformation at tube end. Rc increases with coli length and could approach to 1; inversely, it could approach to 0. These results indicate the design optimization method based on the sequential coupling numerical simulation is feasible, which can be used to realize the controllable and precise deformation of metal tube.
Key words: homogeneous radial deformation; design optimization method; electromagnetic forming; aluminium tube
Superintended by The China Association for Science and Technology (CAST)
Sponsored by The Nonferrous Metals Society of China (NFSOC)
Managed by Central South University (CSU) 湘ICP备09001153号-9